CAN Bus Hardware Verification

4. February 2020 04:46 by Christian in
CAN Bus TerminationThe termination is used to match impedance of a node to the impedance of the tran

CAN Bus Termination

The termination is used to match impedance of a node to the impedance of the transmission line being used. When impedance is mismatched, the transmitted signal is not completely absorbed by the load and a portion is reflected back into the  transmission line. If the source, transmission line and load impedance are equal these reflections are eliminated. This test measures the series resistance of the CAN data pair conductors and the attached terminating resistors.

1. Turn off all power supplies of the attached CAN nodes.

2. Measure the DC resistance between CAN_H and CAN_L at the middle and ends of the network.

The measured value should be between 50 and 70 Ω. The measured value should be nearly the same at each point of the network. If the value is below 50 Ω, please make sure that:

- there is no short circuit between CAN_H and CAN_L wiring

- there are not more than two terminating resistors

- the nodes do not have faulty transceivers.

If the value is higher than 70 Ω, please make sure that:

- there are no open circuits in CAN_H or CAN_L wiring

- your bus system has two terminating resistors (one at each end) and that they are 120 Ω each.

 

CAN_H/CAN_L Voltage Verification

Each node contains a CAN transceiver that outputs differential signals. When the network communication is idle the CAN_H and CAN_L voltages are approximately 2.5 volts. Faulty transceivers can cause the idle voltages to vary and disrupt network communication. To test for faulty transceivers, please

1. Turn on all supplies.

2. Stop all network communication.

3. Measure the DC voltage between CAN_H and GND

4. Measure the DC voltage between CAN_L and GND

Normally the voltage should be between 2.0 V and 4.0 V. If it is lower than 2.0 V or higher than 4.0 V, it is possible that one or more nodes have faulty transceivers. For a voltage lower than 2.0 V please check CAN_H and CAN_L conductors for continuity. For a voltage higher than 4.0 V, please check for excessive voltage.

 

CAN Bus Ground Verification

The shield of the CAN network has to be grounded at only one location. This test will indicate if the shielding is grounded in several places: 

1. Disconnect the shield wire (Shield) from the ground.

2. Measure the DC resistance between Shield and ground.

3. Connect Shield wire to ground.

 The resistance should be higher than 1 M Ω. If it is lower, please search for additional grounding of the shield wires.

 

CAN Transceiver Resistance Test

CAN transceivers have one circuit that controls CAN_H and another circuit that controls CAN_L. Experience has shown that electrical damage to one or both of the circuits may increase the leakage current in these circuits. To measure the current leakage through the CAN circuits, please use an resistance measuring device and:

1. Disconnect the node from the network. Leave the node unpowered.

2. Measure the DC resistance between CAN_H and CAN_GND.

3. Measure the DC resistance between CAN_L and CAN_GND.

Normally the resistance should be between 1 M Ω and 4 M Ω or higher. If it is lower than this range, the CAN transceiver is probably faulty.

Comments are closed